End Cap Glue
Solvent-borne, toluene-free special contact adhesive for industrial and professional use.
A contact adhesive that bonds on contact and reaches full strength in about two days — suited to rubber, leather, gasket, sheet, moulding, metal and lining materials.
- Cures 5 – 15 min
- −40 °C to +75 °C
- Approx. 4 m² / l
Technical data
| Application temperature | +10 °C – +40 °C |
|---|---|
| Using temperature | min. +5 °C |
| Temperature resistance | −40 °C – +75 °C * |
| Curing time | 5 – 15 min (depending on conditions) |
| Open time | 10 – 40 min |
| Density | 0.83 g/ml |
| Dosage | approx. 4 m² / l |
| Colour | Yellowish |
| Phase | Slightly yellowish liquid synthetic rubber solution |
| Tools | Brush, roller or spray gun |
| Packaging | Steel cans · 1, 3, 10, 20, 200, 1000 L |
| Cleaning | Acetone (product and tools) |
| Storage stability | 12 months · +5 – +25 °C, dry |
| Fire | Highly flammable |
| Transport | ADR UN 1133, class 3.1 |
* Heat resistance of the dry seam is approx. +75 °C. Read the safety data sheet before use.
About this product
Surfaces must be clean, dry and free from grease and dust, and may be coarse-ground. Apply a thin, even layer to both surfaces with a brush or roller — for spray-gun use it can be thinned with 5–20 % acetone. Let it dry for 15–40 minutes depending on conditions, then press the surfaces firmly together, checking for air bubbles.
Over-dried surfaces can be reactivated with heat; if heated, press together while still warm. The bond holds immediately and develops full strength in about two days. The dried adhesive is freeze-resistant.
The product is highly flammable and harmful — read the safety data sheet before use and dispose of residues as hazardous waste; the cans are recyclable.
Need this for a project?
Tell us the diameter, length and application and our technical team will confirm the right liner and resin combination.